A:AnswerI would check the impedance of your speakers and compare with the specs of the ones that came with the product. If they are the same it might work ok.
A:AnswerNo, there is no keyhole behind the two side speakers. There is a screw like hole in the middle/back part of the two side speakers, which I am assuming is for hanging speakers or for speaker stands, not sure!
A:Answermake sure you read the directions when setting up the soundbar! Make sure all your connections are connected properly and you have your remote set on the proper setting! If there still is no sound, call the customer service number at vizio, they are pretty knowledgable and helpful! Good Luck!
A:Answerit doesnt. if your tv can control the soundbar itself, then you are good. this has a very small IR receiver on the left, next to the volume indicator which, frankly, sucks. you need a clear, straight line for it to work. my tv can control it with an IR passthrough, so i just use that.
A:AnswerI used, Sanus Home Theater Speaker Stands, Model: HTB3-B1. It is perfect for the rear speaker and very easy to install, the only problem is that you have to cut speaker cable when routing the wire through the upper and lower pillar and out through the base. I marked one cable to make sure I do not change polarity.
A:AnswerYes, you can. You are able to adjust a ton of different settings on this with the controller provided. You can even turn the subwoofer off completely if you wanted.
A:AnswerNot that i know of.. I phone couldnt detect it when i was using the serch for device when i was setting it up for the 1st time. I tried to see if my labtop or phone could see it, but it was no finding it.
