
Enhance your home theater system with this Definitive Technology SuperCube 2000 LAWAA 650W powered subwoofer that features a 7-1/2" high-excursion subwoofer driver and 2 Planar low-bass radiators for deep, musical low-end audio.
A: Speaking about the tower speakers w/subs then yes, just use the high level inputs (ie the black and red terminals). Unplug the sub wire (LFE) and power cord you dont need it, since its for the sub amp. This is what I did with my bp8040-st's.
Q: I need to order the fuse and the part that holds it in place. Can I order it from the Geek Squad?
A: Call DefTech and they can send you one.
A: Hello, the Subwoofer is not Bluetooth and must be connected using a hardline. However, after market wireless subwoofer kits are available.
A: Yes as long as the Edifer R1850DB is sending out a filtered bass signal. Connect a 3.5mm from sub out on Edifer speakers to RCA LFE subwoofer input. You will need a 3.5mm to RCA cable. The Super Cube does not have a low pass filter (cross over built in). Please consider our new Subwoofer line up. The DN10 or DN8. Both now have a low pass filter allowing you to fine to the crossover point.
A: See page 8 of the manual https://s3-us-west-2.amazonaws.com/assets.soundunited.com/definitive/product_documents_legacy/SC%202000%20Manual_12.21.10_web.pdf?mtime=20161003165515 Your wall jacks show a single RCA jack on what I assume is the connection block for the rear speakers. What I can't see is if this is on the wall your speakers are to be located or if this is in the closet your receiver is in. If on the wall connect a standard RCA cable from the RCA jack on wall (top right) to the LFE input of the SuperCube 2000 and then on the other end, where the receiver is located, connect the RCA jack to your sub output on your denon with a standard RCA cable. For better performance upgrade your RCA cables to higher quality cables specific for subs.
A: make sure the lfe out cord is in there correctly if it wiggles a little bit the sound shuts off I thought it had a bigger problem but that's all it was was just a cable end was loose it could be the fuse,I have the super cube 2 and on the back it has a fuse, there a slot for a small flat head screwdriver, just about a half turn then use your hand to take it the rest of the way out. If that's the problem you should be able to get it at a radio shack type store or a music store just make sure you get the correct one, when you take the fuse out it should have the info on there.
Q: Where can I get a snap-on grill for the Supercube 4000 to protect the front speaker?
A: None available as far as I know.