A:AnswerI was concerned about this at first, also. It is not a real problem - the screws are almost like self drilling screws and the wood is soft so with just a little pressure you can push down on the screw and begin screwing the back down to the frame. If you use the smaller piece as a guide - by using the pre-drilled holes to attach this piece to the frame once you have done that you can line up the larger piece with the smaller piece and carefully begin to screw the screws in to the frame. You can space them out around the frame so that it is secure ( I still had more holes than screws but it was enough to secure the back and that's the key it's still just the back and not going to be seen. I did it without a power screwdriver so it's not hard just time consuming!)
A:AnswerThe overall cabinet is 26" tall x 47.5" wide x 15.5" depth.
The top two side by side compartments are 8" tall x 21.5" wide x 14.5" deep.
The 2 bottom left open shelves are 6.5" tall x 17" wide x 13" deep.
The middle tall section area is 13" tall x 8" wide x 13" deep.
The right side that looks like 2 drawers is actually 2 hidden shelves that are just like the left side, but hidden behind a door that looks like drawers. The measurements are the same as the left side at 6.5" tall x 17" wide x 13" deep.
I hope this helps.
A:AnswerYes, just don't install the magnetic door stops. You'll have the holes in top and bottom right corners for the door pivot pins, but if you don't mind that, it will otherwise look the same as the left side.
A:AnswerNot sure what is meant by free standing mount. Can tell you that it accommodates a 65" Sony tv with the brackets provided and is stable. There is about an inch and a half gap from the floor in front and back.
A:AnswerHi! This model is not available in black, however, we will take your question in consideration for further models. Viri E. Insignia Support. https://www.insigniaproducts.com/contact-us
