Questions & Answers

Q: QuestionWhat kind of circuitry does this amplifier use?

• A:Answer This amplifier uses Class D circuitry for reliable power handling.

Q: QuestionWhat is the signal-to-noise ratio of this amplifier?

• A:Answer This amplifier has a signal-to-noise ratio of 95dB.

Q: QuestionDoes this amplifier have a variable low-pass filter?

• A:Answer Yes, this amplifier has a variable low-pass filter that allows you to adjust the audio frequency from 50Hz to 200Hz.

Q: QuestionCan this amplifier power subwoofers from other brands?

• A:Answer Yes, this amplifier can power just about any subwoofer system, whether it's KICKER or not.

Q: QuestionDoes this amplifier come with a remote control?

• A:Answer No, this amplifier does not come with a remote control.

Q: QuestionWill this amp completely power the q class dual L7 12" preloaded box?

Asked 4 years ago by question.

• A:Answer It should be enough power. I'm using it to power the Kicker Solo-Baric dual 12" factory-box (44DL7S122) and it is definitely enough for these subwoofers. Be careful with the power/ground set screws, they strip/cross-thread easily!

  Answered 4 years ago by KPG1281970

  • 
  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDo this 1800.1 work good with 3 Kicker Comp c 15's ...RMS 600/ Max Peak 2400. Right now i have the kicker cxa 1200.1 pushing 2 Kicker Comp 15's l wanna a 3rd Subwoofer was wonder will my cxa 1200.1 amp handle 3-15's Kicker Comp

Asked 4 years ago by Jermaine.

• A:Answer It's rated at 3600 watts, peak power. I've seen it dyno tested on YouTube, at around 2800. You could turn your volume on your radio up to 70% It's max, then adjust your gain from there. Then adjust your x-over, and bass boost on the amp. As well as your subwoofer settings on your stereo. Saves you from blowing your equipment.

  Answered 4 years ago by Mrgbang

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionI have 4 SkarZvx-8D2 (2 ohm DVC 900w rms ea) I have them wired in series/parallel 1 ohm load to kicker CXA1800.1 (the 1 ohm stable one) 2 batteries and 2 alternators running 4gauge power wire and 4 gauge ground. Having problems clipping at low volume.

Asked 2 years ago by Anonymous.

• A:Answer U need to run 1 ga wire with that amp its a little power hungry. Scar audio makes a wire kit wit fuse and every thing u will need for a reasonable price i use it in my sons truck with no issues should solve your problem. Im not a expert but hooked my sons up with 4 gauge till the 1 ga kit came in and had issues. Hope this helped

  Answered 2 years ago by AnonymousVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWill the cx 1800.1 push 4 comp r 8 800rms

Asked 3 years ago by Aaron.

• A:Answer Yes, I have 4 12’s, no problem.

  Answered 3 years ago by ghost16202Verified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionI have a sealed box with 2 x 12 inch kicker brand comp type r’s, can I run a 1800 watt kicker amp

Asked 3 years ago by Jerk.

• A:Answer Yes would work with what you have !

  Answered 3 years ago by JuanIniguezVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDoes this amp have enough power to push 2 solo baric L7 15 dual voice coil 2ohm. Or should I look for something with 5000w ?

Asked 6 days ago by Tee.

Q: QuestionIs this amp 1800 rms at 2 ohm or 1 ohm?

Asked 2 months ago by Anonymous.

Q: QuestionWill it push 2 15 l7 1000w rms ea

Asked 5 months ago by FreddieS.

Q: QuestionHow many volts dose the kiker 1800 have on the output

Asked 9 months ago by Sacramento.

Q: Questioncan i use this on one kicker vx 15

Asked 1 year ago by LL.

Q: QuestionWill the kicker 1800.1 amp be stable pushing 2 15inch q series subs at 2 ohm or what's the best speaker wiring for that amp ?

Asked 1 year ago by 44cwar.

• A:Answer Yes. That particular amp is 2 ohm stable and is more than capable of powering both those subs

  Answered 10 months ago by Anonymous

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionWhat amplifier would be best to run 1 10” kicker comp c with 2 kicker 6 by 9’s. With a line out converter.

Asked 1 year ago by Nick.

• A:Answer Youd actually want to run two different amps one for your voice and one for the subs

  Answered 1 year ago by MichaelVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionI have a set of MTX 2 12's and the box is vented I was wondering if this amp would work with the subs.

Asked 2 years ago by Johnny.

• A:Answer Not sure your rms but I have them on 2 kicker comp q that are rated at 850 rms each and it does great on them.

  Answered 2 years ago by AdamFVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: Questionwill this push 2 kicker comp q (circle) subs on stock electrical? TIA

Asked 2 years ago by Anonymous.

• A:Answer Yes I have this set-up. Do need zero gauge wire. Also will dim your lights without an upgraded alternator. But will still work on stock set-up

  Answered 2 years ago by AdamFVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)