Surround yourself with the rich tones of this Klipsch Reference II floor standing speaker. The 1-inch aluminum tweeter minimizes distortion and is paired with a square Tractrix horn for clean, natural sound. This Klipsch Reference II floor standing speaker features two 6.5-inch spun-copper woofers that provide deep, vibrant bass for the ultimate listening experience.
A: This speaker is amazing. To be honest I enjoy listening to music through this speaker more than I do than watching a movie. I think you’ll be thoroughly impressed by the clarity and bass response of this speaker. It’s a high quality speaker and the sensitivity is over 90 so it’s definitely good in all listening situations.
A: The 620 is a tower speaker usually used in pairs .for stereo, or surround Systems . You need a center speaker a R52C is one example , there are many to choose from 200$ to 1000$ .best buy ,and Klipsch . Can show you .some people ,like sound bars that sit in front of tv . An hook to tv . Klipsch Herseys ,ahh extremely wonder sound . I have a receiver with Atmos hooked to tv .Sony dh790 . You use a. Left , center for voice , and right ..two in back . I have a sub .too .all Klipsch .this is a5.1 setup .,dh 790 is a 7.1 or 5.1.2 . Where I put two one left an right at ceiling facing out . Added two more Klipsch for this . Tv movie 5.1.2 surrounds you .with center speaker you hear all the voices . With the other 7 surround you. I don't like sound bars . You could use 620 as center with tv out plug an amp .
Q: are wires and everything included or is it just the speaker? thanks
A: Just the speaker, stabilizing feet, and screws to attach the feet.
A: You can run any speaker with 1 watt of power. My Sony str-dn1080 (7.2) has a max of 165 watts and that is considered a very good amount of power. So they will definitely get fed well. You don't need to worry. Watts will change depending on volume and other factors. As long as you don't go pass 400 watts and the recommended sensitivity, all will be good.
A: I only took the cover off to photograph the Speaker. Cover on or off does not affect the speaker's sound.
Q: Do these speakers accept banana plugs?
A: Yes they do. That's how I have mine hooked up to my receiver.
A: The woofers on the R-620F are measured between the copper colored torque screws. Please make sure the R-620F is connected to a receiver that supplies close to 100 Watts per channel at 8 Ohms. It may be worth performing a recalibration of your receiver and checking the crossover settings. Klipsch recommends a crossover setting close to 80Hz for the R-620F.
Q: I have an onkyo 1974 receiver I mainly listen to FM radio what is my better speaker choice
A: these speakers will make your 1974 receiver come alive.