A:AnswerThe raw line out is not controlled. It's the signal that usually goes to a tape deck for recording. If your amp has volume and equalizer controls then you could run the line out to it via the RCA plugs. If it doesn't I think what you are looking for is a preamp.
A:AnswerHi there, thanks for your inquiry! The STR-DH190 Bluetooth stereo receiver has an audio analog output for an active speaker or soundbar connection. You can connect a soundbar that supports RCA audio cable connection. Thanks! -Sam
A:AnswerYes it does. I have 8 ohm speaker now and its not the best for it. My volume is always at 25 or higher to get any sound. This is an entry level amp and not ideal for a traditional hi-fi setup. Its just enough to get music for blue tooth connection and FM stereo. I would pay extra to get the right amp if looking for a hi-fi setup and not this one.
A:AnswerHi there, Good question! This receiver features a very good FM signal reception using the supplied FM antenna. And to ensure optimal signal reception, please follow these steps:
Adjust the position of the supplied FM wire antenna (aerial) to a place where the reception condition is good.
Place the antenna near a window.
Position the antenna as horizontally as possible.
Hope this helps!
-Sam
A:AnswerHi KingStormin, Good question. Yes, you can. However, you may need a transformer to make the STRDH190 work since US models will require 120 V AC, 60 Hz. Hope this helps! -Sam
