CORSAIR - Carbide Series SPEC-DELTA RGB Tempered Glass Mid-Tower ATX Gaming Case - Black

Really nice case fans run quite plenty of room to run cables and really like the glass side has good air flow my computer never gets hot

My only complaint about this case is that literally, the minute I finally put the removable sides back onto the case, the RGB light in the top fan stopped working. I have check the cabling and cannot find any disconnect between the fans and the motherboard. The bottom two RGBs work great. It's kindof ironic, I did not really want RGB lights, but bought the case at the last minute to assemble a PC before Christmas. After 11 years between builds, there was a learning curve. Asus VIBE controls the LEDS and the keyboard lights. The case is solid and quality built. I just can't give it five stars with an LED going out within a couple of weeks of purchasing the case. If anyone from Corsair would like to comment, I'd sure like to know if this is a known issue and/or if there is a replacement fan I can order, because I'm not taking the whole machine apart to get the case repaired.

The case come with 3 fans preinstalled and wired to the daisy chain so they only take up one RGB header on your mother board. I built a X570 AMD based set up in it with a GTX 2070 Super, 32GB, a Corsair AIO and everything fits perfectly. The build looks pristine sitting on display and the smoked tempered glass front and side panels are very nice. 10/10 I would build in this case a million times over. Cable management was also a breeze with the prefabricated tie down loops!

Love the case. 4 120mm fans pre-installed. Can fit 140mm. Intake and exhaust fan speeds can be adjusted separately if you need more air. 3 rgb front fans all hooked together so you only need one rgb and one power plug to run them all. Don't have them yet but can put fans on top as well. Wires are all nicely hidden in behind. Everything fit great. One reviewer said his graphics card only left about a fingers width in front of the fans so check length of your going with a big card. Only think i would change maybe is the grating above the top intake fan could be bigger for more air but, might be just me.

Its been a great case no problems at all! Looks great also!

I have had this case for some time, it is not at all AIO friendly, it will not accommodate any size aio bigger than 120mm/140mm. I have a 2080 gaming x trio and there's less than a finger width between the front fans and the gpu. If you have a high end Mobo and a decent sized gpu good luck fitting any AIO. I have mine mounted at the top and you cannot access anything at the top of the motherboard without removing the entire water cooler and radiator. This case would be good for anyone with a small gpu and an air cooled cpu. If you want to build a decent water cooled system with a gpu that has enough fans to keep cool, I highly suggest a different chassis/case. Build quality is good however when the specs state it will fit an aio cooler it is recommended to actually fit them with the average components installed instead of saying it will fit them in only the perfect specific conditions.

It truly is a beautiful case and almost anything can fit into it. It is easy to build in and take apart. The airflow is perfect because it comes with 4 fans so there is no need to purchase any other to complete your build. Then to top it off. You can get it for under 80 dollars. You can’t beat it!

Great case for a first time builder. Only issue I have is cable management is tight! Easily fit my RTX 2060 Super. Only complain I have is that if i had chosen any other ram I may not have been able to fit the AIO in the top bc there is only about 2 mm of space between the AIO rad fans and the RAM. Other than that awesome case.