A:AnswerThey are the red and white cables that come out of the back of your turntable. Plug them in to the back of your amplifier for left and right channel separation.
A:AnswerBy using a tuned stylus suspension system and a low-resonance polymer cartridge body. It is also important to match the compliance of any cartridge to the effective mass of the tonearm it is to be used with in order to keep the resonance frequency of the tonearm/cartridge combination within the preferred resonance frequency range (7 to 12 Hz).
A:AnswerAs long as the Dual cartridge carrier (aka sled) will accept cartridges that take top mounted screws (and I believe it will), because the AT-VM95 Series cartridges have threaded bodies. The screws have to point down, passing through the carrier then threading into the cartridge body.
A:AnswerCheck the tip of your stylus for debris. Check the general condition of the stylus assembly. For example, is the cantilever centered under the cartridge. Check your tonearm for proper calibration to insure the tracking force (stylus pressure) is accurate. Experiment with the Anti-skate setting.
