“My closet is 33-1/2" deep. Unit is 27-1/4" deep, so I have 6-1/4" for duct in back. Is this enough space to install flexible metal (foil type) transition duct to maneuver to out of dryer then to the side hole in closet?”
Answer This Question
1-2 of 2 Answers
I had to purchase this unit for the same reason. I have about the same amount of space you do and it fits perfect. It also has punch out holes on both sides for the duct to run out.
Sorry, there was a problem. Please try again later.Hi Sue- Good question; The recommended duct length and number of bends of the exhaust system depends upon the type of duct, number of turns, the type of exhaust hood (wall cap), and all conditions noted below. The maximum duct length for rigid metal duct is shown in the table below pg. 7: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" both sides and rear, 1" front and top. Thanks for asking; You may contact Us directly by email or chat: http://www.geappliances.com/ge/service-and-support/contact.htm?icid=GEARtopnav-contact Thanks & Always, Kaye@GE
Sorry, there was a problem. Please try again later.
