A:AnswerThis range requires a single-phase, 3 wire, A.C 120/208 V or 120/240 V 60 Hz electrical system. Use only a 3-conductor or a 4-conductor UL- listed range cord with closed-loop terminals, open-end spade lugs with upturned ends or similar termination. Do not install the power cord without a strain relief. A range cord rated at 40 amps with 120/208 or 120/240 minimum volt range is required. If a 50 amp range cord is used, it should be marked for use with 13/8" diameter connection openings. This appliance may be connected by means of a conduit or power cord. For further assistance, please reach out to our technical support team via private message on Facebook @LGUSSupport and use #VOC in your first message to our social media support team or call at 800-243-0000. Also, be sure to provide your contact information, model/serial numbers and date of purchase. ^Daphane
A:AnswerPlease reach out to our technical support team via private message on Facebook @LGUSSupport and use #VOC in your first message to our social media support team or call at 800-243-0000. Also, be sure to provide your contact information, model/serial numbers and date of purchase. ^Daphane
A:AnswerWe hate hearing you are having an issue with your unit. We’d like to gather more information to see if we can help. If the Control Panel Display lights up error code “F9” it means oven failed at exceeding 150ºF after 5 minutes of preheating. Please contact LG Customer Support via private message on Facebook @LGUSSupport and use #VOC in your first message to our social media support team. Please be sure to provide your contact information, model/serial numbers, and date of purchase so that we can better investigate and quickly assist you with a resolution, where possible. We apologize for any inconvenience this has caused. ^Daphane
A:AnswerThis oven has Easy Clean and Self Clean. LG’s EasyClean® enamel technology provides two
cleaning options for the inside of the range. The EasyClean® feature takes advantage of LG’s new
enamel to help lift soils without harsh chemicals, and it runs using ONLY WATER for just 10 minutes in low temperatures to help loosen LIGHT soils before hand-cleaning. The Self Clean cycle uses extremely hot temperatures to clean the oven cavity. While running the Self Clean
cycle, you may notice smoking or an odor. This is normal; especially if the oven is heavily soiled. ^Daphane
A:AnswerNo not inherently. You can get a 5-pack of child safety knob covers that are clear for them though which is what I use for my knobs with a toddler around.
A:AnswerIt's in an awkward stop. Open the top oven door and look up on the left side directly under the two burner knobs on the left. The sticker is facing towards the floor.
A:AnswerHi Nick, This model call for 40amps. Using the 30 A receptacle is a dangerous idea. The internals of the receptacle are designed for a maximum of 30 A, and putting 40 A through it could cause a fire. The receptacle needs to be replaced with a 50 A model (since they don't make 40 A receptacles). ~Tanisha