A:AnswerDear Customer,
This combination unit, model WET3300XQ, cannot be used on a standard 110 outlet. This unit will require a 3 or 4 wire, single phase, 120/240 volt,60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply.
Thank you for your interest in a Whirlpool combination unit!
A:AnswerDear Valued Customer:
Thank you for your inquiry regarding Whirlpool washer dryer combination model WET3300XQ.
Yes. You may wash and dry at the same time.
Thank you again for your inquiry. We appreciate and value your business!
A:AnswerDear Customer,
This combination washer and dryer is currently only available in white. The depth of the unit is 32", or 47 1/2" with the door open 90 degrees.
Thank you for your interest in a Whirlpool combination unit!
A:AnswerDear Customer:
This combination unit, model WET3300XQ, will require 1" of clearance on either side as well as 5" of clearance at the back of the appliance. For specific closet installation clearances please see the Installation Instructions packaged with the combination unit or available to download from Whirlpool.com.
Thank you for your interest in our Whirlpool appliances!
A:AnswerDear Customer:
The dimensions for model WET3300XQ are as follows:
Height : 71 3/4 inches
Width: 27 1/4 inches
Depth: 32 inches
Thank you for your interest in a Whirlpool laundry center!
A:AnswerDear Customer:
On WET3300XQ the height of the exhaust vent at the back of the unit is 25 inches from the floor. For detailed venting specifications please see the Installation Instructions available at Whirlpool.com.
Thank you for your interest in Whirlpool appliances!
A:AnswerDear Valued Consumer:
Any electric combination Thin Twin including model WET3300XQ will be 240 volt, 30 circuit. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit.
Thank you for your interest in Whirlpool combination unit.
A:AnswerDear Customer:
The depth for this unit consists of 32 inches. Please select the following link to review the dimension guide:
http://www.whirlpool.com/digitalassets/WET3300XQ/Dimension%20Guide_EN.pdf
Hopefully this information is beneficial to you. Thank you for your inquiry regarding our Whirlpool appliances!
A:AnswerDear Customer:
To find the appropriate power cord please call our Customer Support Line at 800-344-1274 or download the complete parts list from www.Whirlpool.com/Service_Support by clicking on the Manuals & Literature option.
Hopefully this information is beneficial to you. Thank you for your inquiry regarding our Whirlpool appliances!
A:AnswerDear Midnitegse:
Your washer will require you to obtain new washer hoses. You may contact our parts distributor Marcone, at 877-486-2371 to place your order. Parts Specialists are available weekdays from 8 am to 8 pm CST.
Hopefully this information is beneficial to you. Thank you for your inquiry regarding our Whirlpool appliances!
A:AnswerDear Jamie V:
There is not a kit that can be used for installation with a kitchen sink. This unit requires the use of hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves with water pressure of 5–100 psi, and will need to be installed in a location that allows for proper exhaust installation. For specific information please see the installation requirements listed inside the Installation Instructions packaged with the appliance and available to download from Whirlpool.com.
Thank you for your interest in Whirlpool appliances!
A:AnswerDear Customer:
We do not recommend the venting system of WET3300XQ be any longer than 15 feet when using three 90 degree turns. For specific venting requirements and measurements please see the Ventilation Specification section in the Installation Instructions available to download from Whirlpool.com.
A:AnswerDear Customer,
Please check your local store for pricing of any accessories you need to install this laundry center.
We appreciate your interest in Whirlpool appliances!
Thank you.